Book Errata
Beginner's Guide to SOLIDWORKS 2016 - Level II
Sheet Metal, Top Down Design, Weldments, Surfacing and Molds
Out of Print
Published February 25, 2016
620 Pages
ISBN: 978-1-58503-993-7
- View Errata
- Submit Errata
Errata
- Chapter 3 Page 45
Step 3.11 should read: "20.62 cubic inches"
- Chapter 9 Page 151
Step 9.5 should read: "...make the pin smaller than the hole by offsetting the hole's edge 0.05". "
- Chapter 10 Page 202
Step 10.35 should read: "... 3″ wide by 2″ high rectangle"
Submit Errata
Your information will remain private. We will only use your information if we need to contact you for further details regarding the correction you submit.