Book Errata
Beginner's Guide to SOLIDWORKS 2017 - Level I
Parts, Assemblies, Drawings, PhotoView 360 and SimulationXpress
- View Errata
- Submit Errata
Errata
- Chapter 1 Page 87
On 2.48 you are asked to change a dimension. The wrong dimension is pictured. The correct image is shown below.
Below are the revised images.
- Chapter 1 Page 133
Bullet point two under tips should say: Draw the revolved feature's profile using the following dimensions
Below are the revised images.
- Chapter 2 Page 162
Exercise 8, the shell thickness is missing. It should be 0.125" The updated Crankshaft's drawing's image is provided below.
- Chapter 2 Page 164
The oil pan gasket thickness is incorrectly listed in the book. Please use the image below.
- Chapter 2 Page 221
The keyway's depth dimension is missing. The updated Crankshaft's drawing's image is provided below.
- Chapter 3 Page 332
The Crank case top dipstick thread count should say to make the thread pitch .075" with 3 turns.
Submit Errata
Your information will remain private. We will only use your information if we need to contact you for further details regarding the correction you submit.