Book Errata
Beginner's Guide to SOLIDWORKS 2017 - Level II
Sheet Metal, Top Down Design, Weldments, Surfacing and Molds
Out of Print
Published February 9, 2017
600 Pages
ISBN: 978-1-63057-064-4
- View Errata
- Submit Errata
Errata
- Chapter 3 Page 47
Step 3.11 should read "the volume of liquid inside the bottle up to the fill line is 337.84 milliliters"
- Chapter 9 Page 157
Step 9.5 should read: "...make the pin smaller than the hole by offsetting the hole's edge 0.05". "
- Chapter 10 Page 208
Step 10.35 should read: "... 3″ wide by 2″ high rectangle"
Submit Errata
Your information will remain private. We will only use your information if we need to contact you for further details regarding the correction you submit.