Book Errata

Errata

Chapter 1 Page 41

Autodesk has replaced Autodesk 360 (A360) with Autodesk Drive. The functionality covered in the book is similar in Autodesk Drive. Following the links provided in the book will provide you with a link to the new site. Alternatively, use this link to access Autodesk Drive: https://drive.autodesk.com/

Chapter 3 Page 17

Step 28 should instruct you to select the Mirror - Pick Axis tool. The icon shown next to the instructions is correct.

Chapter 3 Page 20

Step 9, the directions correctly indicate to put the information about the elevator in the Model, Manufacture, and URL. The corresponding figure, figure 3-4.2, in the book incorrectly shows it in the Keynote, Model, and URL. Please reference the corrected image below.

FIGURE 3-4.2 Elevator properties

Chapter 4 Page 2

Step 4. b. Should instruct you to adjust the Range Base Level (Underlay) to None.

Chapter 6 Page 1

Exercise 6-1: Hip Roof, under the section: Add Level Datum, Step 1. the directions should direct you to open the file ex5-6.rvt and save it as ex6-1.rvt.