Book Errata
Engineering Analysis with SOLIDWORKS Simulation 2019
- View Errata
- Submit Errata
Errata
- Chapter 3 Page 87
Second line from top should read 0.2478
- Chapter 8 Page 164
The last paragraph contains the sentence:
"Do not select any face of the MICROCHIP."It should say:
"Select all faces of the MICROCHIP except the one touching the RADIATOR."- Chapter 8 Page 172
The last paragraph should read: To see the temperature history at selected locations right-click the temperature plot and select Probe to probe temperature in the location shown in Figure 8-12.
- Chapter 9 Page 177
The second paragraph should read: Open the HANGER assembly (Figure 9-1) and create a Static study. Right-click Global Contact in the Components Contact folder to open the Component Contact window (Figure 9-2).
- Chapter 14 Page 273
The first sentence should read: In the SOLIDWORKS Feature Manager, define a Sensor in the location indicated in Figure 14-30.
- Chapter 15 Page 292
The second to last sentence should say that there are eight gaps in the model.
- Chapter 17 Page 332
The first sentence should start by asking you to: "Open the PRESSURE VESSEL model in 02 flat section configuration..."
- Chapter 19 Page 397
Below Figure 19-2, there is the sentence: As shown in Figure 19-2, calculating the mean square value gives Grms^2 = 0.27G. The units should be G^2, not G.
- Chapter 20 Page 430
The sentance:
"Define a non-uniform pressure to the blue hemisphere as shown in Figure 21-9."Should say:
"Define a non-uniform pressure to the blue hemisphere as explained in NON UNIFORM LOAD example in chapter 21”
Submit Errata
Your information will remain private. We will only use your information if we need to contact you for further details regarding the correction you submit.