Book Errata
Engineering Analysis with SOLIDWORKS Simulation 2020
- View Errata
- Submit Errata
Errata
- Chapter 3 Page 87
The second line from top should read 0.2478
- Chapter 8 Page 167
The first paragraph contains the sentence:
"Do not select any face of the MICROCHIP."It should say:
"Select all faces of the MICROCHIP except the one touching the RADIATOR."- Chapter 8 Page 174
The last paragraph should read: To see the temperature history at selected locations right-click the temperature plot and select Probe to probe temperature in the location shown in Figure 8-12.
- Chapter 9 Page 179
The second paragraph should read: Open the HANGER assembly (Figure 9-1) and create a Static study. Right-click Global Contact in the Components Contact folder to open the Component Contact window (Figure 9-2).
- Chapter 14 Page 277
The first sentence should read: In the SOLIDWORKS Feature Manager, define a Sensor in the location indicated in Figure 14-30.
- Chapter 15 Page 296
The second to last sentence should say that there are eight gaps in the model.
- Chapter 17 Page 336
The first sentence should start by asking you to: "Open the PRESSURE VESSEL model in 02 flat section configuration..."
- Chapter 19 Page 401
Below Figure 19-2, there is the sentence: As shown in Figure 19-2, calculating the mean square value gives Grms^2 = 0.27G. The units should be G^2, not G.
Submit Errata
Your information will remain private. We will only use your information if we need to contact you for further details regarding the correction you submit.