Book Errata
Engineering Analysis with SOLIDWORKS Simulation 2024
- View Errata
- Submit Errata
Errata
- Chapter 2 Page 51
Figure 2-15 shows the three different mesh sizes, but they incorrectly show curvature-based mesh parameters when they should be set to standard mesh parameters. Please use the corrected image below.
- Chapter 8 Page 171
The first paragraph contains the sentence:
"Do not select any face of the MICROCHIP."It should say:
"Select all faces of the MICROCHIP except the one touching the RADIATOR."- Chapter 22 Page 530
-
Figure 22-38 in the book shows the results of the simulation. The result presented in the book was obtained without symmetry boundary conditions that should have been there. Please see the updated figure below for the correct result.
Submit Errata
Your information will remain private. We will only use your information if we need to contact you for further details regarding the correction you submit.