Book Errata
Engineering Analysis with SolidWorks Simulation 2013
Out of Print
Published March 29, 2013
496 Pages
ISBN: 978-1-58503-784-1
- View Errata
- Submit Errata
Errata
- Chapter 10 Page 185
Under the project description it should read: The temperature of the entire loop shown in Figure 10-1, increases uniformly from an initial 298K to 500K.
- Chapter 14 Page 254
Caption in italics under illustration 14-23 should say:
A linear model cannot distinguish between the two configurations shown in this illustration.- Chapter 20 Page 423
Figure 20-27 The Z coordinate of load application point in the global coordinate system should be 400mm not 414mm Note: make the same change to the 02 short study in the downloadable model PIPES.SLDASM
Submit Errata
Your information will remain private. We will only use your information if we need to contact you for further details regarding the correction you submit.