Book Errata
Engineering Graphics with SOLIDWORKS 2018 and Video Instruction
A Step-by-Step Project Based Approach
- View Errata
- Submit Errata
Errata
- Chapter 3 Page 9
Aligned Dimension, Example 1: The figure points out the 44mm and 10mm vertical dimensions to be "aligned dimensions", when in fact the figure is an example of unidirectional dimensions. In order for the vertical 44mm and 10mm dimensions to be aligned dimensions, the "44" text and "10" text must both be rotated 90 degrees counter-clockwise. This will make the text parallel to their respective dimension lines, which is the provided definition of an aligned dimension.
- Chapter 3 Page 33
In the last figure on the bottom right of the page, the very final line of the calculations should be "Negative Allowance (Interference) = .0009".
Submit Errata
Your information will remain private. We will only use your information if we need to contact you for further details regarding the correction you submit.