Modeling Using Pro/ENGINEER Wildfire 4.0
- Description
- Contents
- Details
Description
Key Features
- Contains models of real machine components and assemblies
- Designed with a flexible four column page layout with detailed illustrations
- Uses detailed instructions for creating good engineering drawings
- Implements the use of both bottom-up and top-down approaches
- Contains additional resources including exercise problems and helpful hints
In Detail
This book synergistically integrates the design process with the specific commands and procedures of Pro|ENGINEER through a unique presentation scheme. Users are first provided with the design information about the part or assembly and its design intent. Then, they see an overview of steps involved in modeling the part/assembly. This is accompanied by detailed instructions showing goals, steps and commands in a four column presentation. The consistent approach is supplemented by many illustrations on each page. Each chapter adds new information while reinforcing key concepts.
The focus of the text is on teaching actual design modeling using Pro|ENGINEER rather than teaching a set of commands. The book illustrates the part, drawing and assembly creation with several industrial examples. Theses parts fit together in the final chapters to form one large assembly.
Table of Contents
- Introduction
- Bearing
- Bearings
- Bushing
- Retaining Ring
- Nuts and Bolts
- Shaft
- Shaft Drawing
- Radial Plate Cam
- Housing
- Cam Assembly
- Cam Follower Assembly
- Washington Monument and Wing
- Gateway Arch
- Springs
- Spur and Helical Gears
- Axial Cam
- Grooved Cam
- Bolt Heads
- Electrical Fuse Assembly
Product Details
Publisher | SDC Publications |
Authors | Sridhar S. Condoor |
Published | December 9, 2008 |
User Level | Beginner |
Pages | 310 |
Binding | Paperback |
Printing | Black and White |
Print ISBN | 978-1-58503-377-5 |
Print ISBN 10 | 1585033774 |