Book Errata
Parametric Modeling with Creo Parametric 3.0
An Introduction to Creo Parametric 3.0
Out of Print
Published September 23, 2014
517 Pages
ISBN: 978-1-58503-912-8
- View Errata
- Submit Errata
Errata
- Chapter 6 Page 40
Step 6, if you cannot select the dimension, set the selection filter (at the lower right of the main screen ) from "Drawing View" to "General".
- Chapter 7 Page 23
The 2nd image should be the same as the 2nd image on page 6-44.
- Chapter 9 Page 22
Step 3 should be 0.0625 inches.
- Chapter 9 Page 29
Step one is not needed.
Submit Errata
Your information will remain private. We will only use your information if we need to contact you for further details regarding the correction you submit.