Book Errata
SOLIDWORKS 2016 Basic Tools
Getting started with Parts, Assemblies and Drawings
Out of Print
Published March 22, 2016
676 Pages
ISBN: 978-1-63057-001-9
- View Errata
- Submit Errata
Errata
- Chapter 3 Page 10
Item A. Click line 1 points to the wrong figure. The image below shows the corrected image.
- Chapter 18 Page 1
The intent is to keep the flange length at .500” measured from the inside face (left image). The sketch line should be changed to .454” if the option Bend Centerline is used (right image). The model shows the correct dimensions but the drawing, for some reason, does not.
- Chapter 18 Page 7
The dimensions on this page have been updated. See the image below for an accurate the corrected dimensions
Submit Errata
Your information will remain private. We will only use your information if we need to contact you for further details regarding the correction you submit.