Book Errata
SOLIDWORKS 2018 Intermediate Skills
Expanding on Solids, Surfaces, Multibodies, Configurations, Drawings, Sheet Metal and Assemblies
- View Errata
- Submit Errata
Errata
- Chapter 2 Page 3
Step 1. Should say - Select the Right plane (not the Front plane).
- Chapter 3 Page 8
Step 6 and 11 - Offset dimension in the dialog boxes should be .040” to match with instruction.
- Chapter 5 Page 16
Thread is through all. Use the surface in the back of the large flange.
- Chapter 6 Page 14
This page says to select the 3 edges. You should only select the opposing single edge.
- Chapter 7 Page 20
Step 20 should say - Click the Flip-Offset checkbox to place the new plane below the face.
- Chapter 16 Page 24
Step 22. The Concentricity is between the .129 Thru Hole and the .266 Bore Hole.
- Chapter 18 Page 8
The 3rd paragraph says: "Repeat the same steps to ensure both corners are identical with each other."
It should read: "Repeat the same steps to ensure both sides are identical with each other."
Submit Errata
Your information will remain private. We will only use your information if we need to contact you for further details regarding the correction you submit.