Book Errata

Errata

Chapter Capstone 2 Page 464

Step 11(a) - should refer users to CP2.22 to determine placement of blocks on the Appliances and Plumbing Plan layers instead of CP2.21.

Chapter Capstone 2 Page 464

Step 11(c) - the list of fixtures to insert on the Plumbing Plan layer should include Gas Outlets.

Chapter Capstone 2 Page 471

There should be a dimension of 3' - 4" placed below and parallel to the bottom edge of the Water Heater closet to indicate the width of the Water Heater closet. This dimension was omitted in error.

Chapter Capstone 2 Page 471

In Figure CP 2.27(b) - There is a superfluous dimension of 0" labeled next to the 32'-0" dimension on the right side of the plan. Do not include this dimension.

Chapter Capstone 2 Page 473

In the Floor Plan Checklist there should be 61 linear or continuous dimensions (not 67 as is currently in the Checklist). The 61 dimensions includes the ones shown on pages 470 and 471 PLUS a dimension of 3'-4" added below the bottom edge of the Water Heater Closet which was omitted in error.

Chapter Capstone 2 Page 473

Floor Plan Checklist – the Viewport scale should be set to 3/16” - 1’-0” instead of 1/4” – 1’- 0".

Chapter Capstone 2 Page 474

In Figures CP2.28 the Roof Pitch notation on the lower roof plane of the Front Elevation (the roof plane supported by the 8" cedar post) should read 4:12 instead of 10:12.

Chapter Capstone 2 Page 484

Step 6(c) and in Figure CP2.44(a) the text informs you to use the Polar Array command to create the lines on the metal roof of the cabin that represent the crimps in the metal, but you should use the Rectangular Array command instead. The figure shows the correct contextual ribbon for the Rectangular Array.

Chapter Capstone 2 Page 485

In Figures CP2.45 the Roof Pitch notation on the lower roof plane of the Front Elevation (the roof plane supported by the 8" cedar post) should read 4:12 instead of 10:12.